Chevy 400 – Level 3 Transmission with Torque Converter
Horse Power: 600
(Up to 550 ft-lbs Torque)
Converter: 10” Heavy Duty Furnace Brazed Flanged Hub with Billet Cover
Master Overhaul Kit with Raybestos Stage 1 Racing Frictions and Hardened Kolene Steels
High Flow Brass Filter
New Kickdown Solenoid
Transgo Re-Programming Shift Kit with Shift Command
A New Front Band
New Borg-Warner Low-Reverse Band with Heavy Duty Lugs
New Torrington Bearings
Bushing Kit with Flanged No Walk-Out Case Bushing
Thrust Washer Kit
New Low-Reverse Spring & Roller
High Capacity Direct 8-Clutch Drum with 34-Element Intermediate Sprag and Hardened Race
Heavy Duty Forward Steel Clutch Hub
Extra Capacity Intermediate Clutch Assembly
High Volume High Flow Pump Assembly with New Gears
A New Extra Capacity Cast Aluminum Transmission Pan with Drain Plug
New Speedometer Drive Gear
New Speedometer Driven Gear
30,000 GVW Hayden Transmission Cooler
Installation Kit: Universal Fill Tube and Stick, Universal Transmission Mount, Universal Converter Cover
Gearstar Has Your Back
AVAILABLE AT ADDITIONAL COST
Please specify Slip Yoke or Bolt on Yoke.
Please specify if ordering for Buick, Olds or Pontiac as well as 2WD or 4WD.
All transmissions are custom built by 1 of 5 master techs from start to finish and DYNO tested with converter the equivalent of 100 miles to insure that transmission and converter package are in perfect operating condition before they leave our facility.
All sales are final. No returns or refunds.
|Measurements are taken from mounting surface where trans meets engine block to the tip of the tailshaft|
|Total Length: 28″ with 4″ Tail Housing 2WD Only|
|Total Length: 31″ with 9″ Tail Housing|
|Distance to trans mount center: 27″|